Dot Gain: Curves, Plates, Ink and Paper

What is dot gain? A dot on a printing plate is a known size, and the dot that lands on paper is larger. Ink spreads under pressure, paper absorbs vehicle and the dot bleeds into the fibre, so a 50 percent dot may print at 60 percent or more. The difference between the intended and the printed tone is dot gain, and it is the usual reason a proof matched on screen looks heavy on the sheet.

Why does the substrate change the number? Coated board has a sealed surface that holds ink on top, so the dot stays close to its intended size. Uncoated and recycled boards absorb vehicle quickly and wick ink sideways, which raises gain substantially. Kraft and test liner behave differently again, and a corrugated liner printed direct carries gain that would be unacceptable on a folding carton. The same file printed on two boards produces two different results, and both can be correct for their substrate.

How is gain compensated? The plate or the raster image processor applies a curve that shrinks the dot in the file so it prints at the intended size. The curve is built from measurements on the actual press, with the actual ink and board, rather than copied from a default. Where a printer runs several substrates, it needs several curves; one curve applied across coated and uncoated work guarantees that one of them looks wrong.

What numbers are normal? On coated board printed offset, gain in the midtones usually lands somewhere between 12 and 18 percent. Uncoated board runs higher, often 18 to 25 percent, and direct flexo on corrugated can exceed 30 percent because the plate and the anilox deposit more ink on a rougher surface. Those ranges are guides, not specifications: the figure that matters is the one measured on the job, against an agreed target such as a recognised print standard.

Why does a photograph look muddy? Shadows close up first. A 90 percent dot with heavy gain becomes a solid, and the separation between dark tones disappears, so detail in hair, fabric and dark backgrounds flattens into a block. Highlights blow out for the opposite reason when gain is over-compensated. Photographs with detail at both ends of the scale need the gain under control before the separation is approved in the first article check, not after the plates are made.

How is gain measured? A control strip printed alongside the job carries tints at known percentages, and a densitometer compares the printed value with the intended one. Without a control strip, the printer is guessing, and the buyer has no evidence either way. Where a job repeats, the measurements from the first run become the reference for the second, which is how consistency is maintained across reprints and across plants.

What should a buyer specify? The print standard the job will be measured against, the tolerance accepted on the control strip, and the substrate the curve was built for. Add a requirement that the first article is measured rather than judged by eye, because a press operator’s eye adapts to whatever is on the sheet after a few hundred impressions. A measured first article catches a wrong curve before the run is wasted.

Chengtop builds plate curves per substrate for corrugated cases and folding cartons at its Wuhan plant, and measures a control strip on the first article of each run. Send the artwork, the board grade and the target standard, and we will confirm how the job will be compensated.

Leave a message
Phone +86 15272060604
Email chengtop888@outlook.com
WhatsApp WhatsApp: 8615272060604
WeChat +86 15272060604
Back to top

Contact Us

Leave a message