A label that was approved on a sample bottle fails on the line at 200 bottles a minute. The label is not necessarily wrong; the conditions it meets on the applicator are different from the conditions in the sample room. Application is a separate discipline from printing, and the questions below cover the variables that decide whether a label stays put.
Why do labels fail on the line? Four causes account for the bulk of it: the surface is contaminated or too cold, the adhesive has not had time to wet out, the applicator is mis-set for the liner, or the label was stored in conditions that changed its dimensional stability. Adhesive needs contact pressure and a moment to flow into the surface. On a high-speed line the dwell time can be a few hundred milliseconds, so a mismatch between adhesive grade and line speed shows up as edge lift within hours.
What temperature does application need? General-purpose permanent adhesives are usually specified for application at container surface temperatures between roughly 5 and 40 degrees Celsius, with the label itself at a similar temperature. Below that range the adhesive becomes too firm to wet out; above it, the film can stretch and the adhesive can become too soft to shear cleanly. Cold-chain filling is the classic failure case, because a bottle taken from a chill store condenses moisture onto the surface just as the label arrives.
Why does surface energy matter? Adhesive bonds by wetting the surface, and wetting depends on surface energy. Untreated polyethylene and polypropylene sit at the low end, which is why containers in those materials are usually flame or corona treated before labelling. Glass and metal are forgiving. A surface that has been treated but has sat for months can lose the treatment, and a mould release agent or a silicone oil residue will defeat any adhesive regardless of grade.
How does line speed change the choice of label? Faster lines need an adhesive that grabs quickly and a liner that releases cleanly at the dispensing beak. A tight-release liner can cause the label to fly or to wrap around the applicator; too loose and the label falls off before it reaches the container. Web tension, gap and beak radius all interact with the material. Where a line runs several pack sizes, the label supplier should know the range rather than the average.
What should a buyer tell the label supplier? The container material and whether it is treated, the fill temperature, the ambient conditions on the line, the applicator type, the line speed, the label size relative to the curve of the container, and the storage conditions before use. A label chosen for a flat panel on a warm line will behave differently on a 25 millimetre diameter vial in a cold room. Sending a few empty containers with the enquiry is more useful than a description.
Does the printing method affect application? It can. A heavily inked or varnished label is stiffer, and stiffness changes how the label follows a curved surface, so a full-coverage dark print may lift at the edges where a lighter design lies flat. Die-cut shape matters too, since a sharp corner is a starting point for peel. The guide to label materials, adhesives and finishes sets out how those choices interact, and the selection article covers the matching of face stock to application.
How should labels be stored before use? In the original carton, sealed, at around 20 degrees and 50 percent relative humidity, away from sunlight and heat. A container in a hot port or a cold container in winter can arrive outside the adhesive’s tolerance, and the fix is to let the rolls acclimatise in the packing hall for a day before running them rather than opening them straight onto the machine. Wet cartons are worse than warm ones, because moisture attacks the liner and the adhesive together.
If a label is failing on your line, send the container material, the fill temperature and the line speed, and we will tell you which part of the specification is likely to be the cause. Start on the quote request page.
Chengtop prints folding cartons, corrugated boxes and labels alongside rigid gift boxes at our Wuhan plant. Message us with the application conditions and we will respond with what suits them.


