Holographic Seals: Residue on Soft-Touch Board
Soft-touch film feels good in the hand but gives an adhesive less to hold, so a tamper seal can either peel away cleanly or leave a patch that reads as damage. The result depends on the film, the adhesive and how long the seal stays on. Test on the finished carton after a few weeks of storage, and place the seal where a residue will not sit beside the logo.
Demander un devis
Indiquez la quantité souhaitée et ajoutez-la à votre liste de devis pour obtenir un devis.
Description
A tamper seal has to leave evidence when it is removed, and it has to leave that evidence on the seal rather than on a patch of the box that still looks like damage. Soft-touch film makes that harder. The velvety surface gives an adhesive less to grip, so a seal can peel away too cleanly in one batch and pull the film off in another.
How Soft-Touch Film Changes the Bond
Soft-touch coating has a fine textured surface, and an adhesive meets only the peaks of that texture at first. Over time it flows into the valleys and the bond strengthens. A seal removed a day after packing behaves differently from one removed after a month in a warehouse. Test both, and ask for the residue pattern to be described on the finished carton rather than on a plain board sample.
Where the bond grows too strong, removal can lift the coating and leave a matte patch on the carton. Where it stays weak, the seal comes away intact and the tamper evidence is lost. A frangible film that breaks within itself gives a clearer signal on this surface than one that depends on a residue pattern left behind.
Placing the Seal Away From Print
A residue patch reads as damage when it sits beside a logo or across a foil mark. Put the seal on a quiet area of the tuck flap or the lid seam, where a slight change in surface sheen is less noticeable. Keep it clear of a barcode, a batch code and any legal text. Where the carton has a window patch, the seal should not bridge the film edge, since that edge is already a weak point.
Seal width belongs with the seam. A narrow seal across a wide tuck flap may not span the whole opening, while a wide one can catch on the box corner during packing. The autocollants de sécurité holographiques range covers void and frangible constructions, and the boîtes pliantes range covers the coated surfaces they are applied to.
Storage Time and Removal Behaviour
Agree how long a pack may sit before it reaches a customer, then test removal at that age as well as at packing. Heat in a container can speed up the change in bond, so a sample kept in a warm room is a useful check. Record what the seal looks like after removal and what the carton looks like underneath, and keep those two photographs with the approval.
Batch Records and Seal Supply
A seal with a serial number or a code has to be matched to the production batch. Keep the seal artwork, the code range and the carton batch on one record so a question from a customer can be answered without guessing. Where several cartons share a seal design, a small quiet area on the seal leaves room for a code without disturbing the hologram pattern.
Checks on the Finished Carton
- Remove a seal a day after application and again after a longer storage spell.
- Photograph both the removed seal and the carton surface underneath.
- Keep the seal clear of logos, codes, windows and foil marks.
- Confirm the seal spans the seam without catching a box corner.
- Record the code range against the carton production batch.
A customer removing a seal will often pull it slowly and at an angle, not in the straight motion used on a test bench. Try that motion on the finished carton and note whether the film breaks within itself or lifts the coating. The result belongs in the approval record alongside the storage test.
Send the carton finish, the expected shelf life and the tamper evidence you need when you ask for a quote. With the film, the adhesive and the placement settled together, the seal gives a clear signal without leaving a mark that reads as damage.







