Thank You Card Stock: Board Weight and Recess Depth
A thank you card that sits in an insert recess has to be thin enough to clear the lid, but heavy enough not to curl when the box is opened. Board weight and recess depth are one decision. Add the tissue wrap and any ribbon to the stack when you measure, and check a closed box with the card in place before setting the die for the recess.
اطلب عرض أسعار
أدخل الكمية التي تحتاجها وأضفها إلى قائمة عروض الأسعار الخاصة بك للاستفسار عن الأسعار.
الوصف
A thank you card sitting in an insert recess has two jobs: it has to lie flat when the box opens, and it has to disappear far enough that the lid closes without pressure. Board weight and recess depth are one decision. Change either on its own and the card either curls or sits proud of the tray.
Board Weight Against Recess Depth
A light card curls at the edges when a box has been stored in a dry room, and a heavy one needs a deeper recess that eats into the insert below. Start with the card stock the brand wants to use, then set the recess depth from that caliper plus a small allowance for the tissue wrap and any ribbon that crosses the tray. Where the insert is moulded pulp, the recess has a draft angle, so the card rests on a sloped floor rather than a flat one.
Card finish changes the thickness again. An uncoated sheet with a blind deboss reads as heavy but adds little, while a laminated card gains a film on both faces. Measure the finished card, not the raw board, before the die is drawn.
Margins Around the Card
A card cut to the exact recess size binds at one corner and lifts when the customer tries to take it out. Leave a narrow even margin on all four sides, wide enough for a fingertip. Where a ribbon pull crosses the recess, give it a shallow channel so the card is not held down by the ribbon itself. A recess that is slightly larger than the card also forgives the small movement of a pulp insert between batches.
Check the closed box with everything in place. A card that looks flat in an open tray can press against a padded lid lining once the lid is shut, and that pressure shows as a line on the lining after a day.
Print and Finish on a Small Card
Fine type on a small card needs a surface that holds a sharp edge. Uncoated stock takes a blind deboss or a simple foil mark well, while a coated sheet keeps small reversed lettering cleaner. Keep the message away from the very edge, where a die-cut can shave a hairline off a rule. The بطاقات الشكر range covers card stocks and finishes, and the نشرات التعبئة والتغليف range covers the recess geometry they sit in.
Storage Before Packing
Cards are often printed ahead of the boxes and stored flat in a stack. A stack kept near a damp wall takes up moisture on one edge, and those cards curl differently from the rest. Keep a sample from the stored batch and try it in the recess before the packing run, rather than relying on a fresh approval sample.
Checks With a Closed Box
- Measure the finished card caliper including any laminate or foil build.
- Set the recess depth from that caliper plus tissue and ribbon thickness.
- Leave a narrow even margin on all four sides for a fingertip.
- Close the box over the card and inspect the lid lining a day later.
- Try a card from a stored batch as well as a fresh sample.
Where a range uses several box sizes, keeping one card size across the set simplifies the packing line but means the recess depth has to be checked in each box. A card that sits well in a deep tray can stand proud in a shallow one. Approve the card with the smallest box in the range.
Send the card stock, the insert material and the box lining when you ask for a quote. With the board weight, the recess depth and the margin settled together, the card lies flat when the lid opens and stays clear of the lining on the way to the customer.







